Prosoft Technology Inc
MVI56-WA-EIP Sample Ladder Logic ReadMe File

1.0 INTRODUCTION

The sample ladder logic should only be used for applications that require ControlLogix access to
module status or configuration information from the MVI56-WA-EIP module.
The sample ladder logic IS NOT required when application requires only ControlLogix programming 
through the MVI56-WA-EIP module (without status or configuration transfer through the backplane). 
Therefore this is an optional feature.  

2.0 APPLICATION

The sample ladder logic allows the ControlLogix to perform the following tasks: 

- Read MVI56-WA-EIP radio status information
- Read MVI56-WA-EIP Ethernet/IP status information
- Read MVI56-WA-EIP configuration information
- Request the reboot of the MVI56-WA-EIP     

Refer to the MVI56-WA-EIP User Manual for further information on how to perform these tasks. 


3.0 COMPATIBILITY

Use ladder logic file MVI56WAEIP_v13 for RSLogix/ControlLogix version 13.xx
Use ladder logic file MVI56WAEIP_v15 for RSLogix/ControlLogix version 15.xx
Use ladder logic file MVI56WAEIP_v16 for RSLogix/ControlLogix version 16.xx

Make sure that your ControlLogix processor has the following firmware version
(otherwise communication problems may occur during the trigger of the MSG instructions): 

Processors 1756-L1: use firmware version 13.34 or later
Processors 1756-L55: use firmware version 15.1 or later
Processors 1756-L61, 1756-L62, 1756-L63 : use firmware version 13.44 or later



