# FLNet.CFG # # This file contains the configuration for the MVI56-FLN communication # module. # # LOCATION : # DATE : # CONFIGURED BY : # MODIFIED : # # This section is used to define the configuration for the Module level # data. # [Module] Module Name : MVI56-FLN # This section is used to configure the FL-Net node emulated on this module. [FL-Net] Node Name : MVI56FLN # These parameters define the Area 1 and Area 2 data to be transferred from # the processor through the module to the network (output data). These sizes # will determine the number of blocks required to transfer the data. Area 1 Top : 0 #0...511 top address for area 1 Area 1 Size : 50 #0...512 area 1 data size in words (0=not used) Area 2 Top : 0 #0...8191 top address for area 1 Area 2 Size : 100 #0...8192 area 2 data size in words (0=not used) Token Watchdog Time : 100 #token watchdog time (1..255) in ms (default=255) Minimum Frame Interval Time : 50 #allowable min frame interval (0...50), 100us units # These parameters define the Area 1 and Area 2 data to be transferred from # the field through module to the processor.These sizes will determine the number # of blocks required to transfer the data (input data area). # These parameters should be reconfigured in order to provide maximum backplane # communication performance while transferring only used data. This configuration # applies to the Network A1/A2 areas (Use BP Map Table = N) BP Area 1 Top : 50 #0...511 top address for area 1 BP Area 1 Size : 50 #0...512 area 1 data size in words (0=none transferred) BP Area 2 Top : 100 #0...8191 top address for area 2 BP Area 2 Size : 100 #0...8192 area 2 data size in words (0=none transferred) # The following parameters refer to the Backplane Mapping functionality. This feature # allows the module to remmap the A1 and A2 Network regions into the optimized # A1 and A2 Backplane regions to be transferred to the ControlLogix processor. # This feature enhances the data throughput performance since the module will only # transfer the data used for each node. # The following parameter allows the module to enable the Backplane Mapping functionality. # Disable the functionality (Use BP Map Table=N) to transfer the network A1 and A2 areas # to the ControlLogix processor without any remmaping. # Enable the functionality (Use MB Map Table = Y) to remmap the network A1 and A2 areas # into the Backplane A1 and A2 areas to be transferred to the ControlLogix processor. # Use BP Map Table : N #Use BP mapping (Y=Use maps, N=Don't use maps (default)) [FL-NET BACKPLANE MAPPING] # Node A1 Network A1 Network A1 Backplane A2 Network A2 Network A2 Backplane # Start Size Start Start Size Start START 40 0 50 50 0 100 100 END