-
Solutions
- Amusement
- Automated Material Handling
- Automotive
- IIoT Solutions
-
Gateways
DH485 Router
A-DH485R/B
The A-DH485R/B DH485 Router provides intelligent data routing between EtherNet/IP™ and DH485, simplifying the migration from MicroLogix and SLC systems with DH485 communications to EtherNet/IP based ControlLogix or CompactLogix platforms.
The module can be used for remote programming of a SLC5/03 controller via Ethernet.
The DH485 Router’s AIC Mode provides direct conversion between RS485 and RS232, an ideal replacement for Rockwell’s 1761-NET-AIC module.Alternatively, the module makes use of the DH485 destination Node Address, (and Data File address in certain modes), to determine the target Logix controller. The mapping table, which can be configured in minutes, supports connections up to 8 Logix controllers.
In Transparent PCCC mode, the user will be able to program and connect to SLC5/03 PLCs.
The module can operate in both Logix “owned” and standalone mode. With a Logix connection, the input and output assemblies will provide additional diagnostics information in the Logix controller environment.The module’s RS485 port uses a terminal block for convenient installation.A built-in webserver provides detailed diagnostics of system configuration and operation, including the display of received DH485 communication packets, without the need for any additional software.
- Abbildungen
- Funktionen und Vorteile
- Konfiguration
- Technische Daten
- Hardware-Spezifikationen
- Downloads
- Zertifikate
Abbildungen
Click on image(s) to enlarge
Funktionen und Vorteile
- 1761-NET-AIC replacement
- Direct-To-Tag technology for Logix Controllers
- Isolated serial ports
- Support for Device Level Ring (DLR) or use as two-port embedded switch
- Intelligent routing to Logix/SLC/MicroLogix
- Support for Reactive tag mapping (Slave) and Scheduled tag mapping (Master)
- Supports PLC5/SLC mapping
- Support for Logix programming over Ethernet for Serial interfaces (SLC/MicroLogix)
- Interfacing of PanelView Plus and PV800 from Ethernet to Serial
Konfiguration
The Slate Configuration Utility software is used for configuration and troubleshooting of the Router. The stand-alone configuration utility allows users to define the setup and configuration of the Router, and connections with controllers and devices.
Technische Daten
EtherNet/IP Network
Specification
Rating
Connector
RJ45
Conductors
CAT5 STP/UTP
ARP Connections
Max 40
TCP Connections
Max 40
CIP Connections
Max 10
Communication Rate
10/100 Mbps
Duplex Mode
Full / Half
Auto-MDIX Support
Yes
Controller Support
ControlLogix, CompactLogix, MicroLogix, SLC
Embedded Switch
Yes, 2x Ethernet ports
Serial Ports (RS232, RS485)
Specification
Rating
Connector
9-way terminal (shared)
Conductor
24 to 18 AWG
Electrical Isolation (RS232)
1000 V DC
Electrical Isolation (RS485)
1500 Vrms (1 minute)
Baud Rate (bps)
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Parity
None, Even, Odd
Data, Stop Bits
8, 1
Error Detection
CRC
DH485 Router
Specification
Rating
Transparent Mode Mapping
Max. 20
Logix Tag Mode Mapping
Max. 20
Reactive/Scheduled Tag Mode Message Support
PLC-5 Type: Read, Write
SLC Type: Read, WriteRockwell Automation Controller programming Support
SLC5xx range
Hardware-Spezifikationen
Specification
Rating
Power Supply
Input: 10 to 32 VDC, (67 mA @ 24VDC)
Voltage Fluctuations
Voltage fluctuations < ±10%
Transient Over-voltages up to the levels of OVERVOLTAGE CATEGORY 1Power Consumption
1.7W, 173mA maximum
Dimensions (H x W x D)
149.0 x 34.0 x 116.0 mm
Connector
3-way terminal
Conductors
24 to 18 AWG
Enclosure Rating
IP20, NEMA/UL Open Type, Indoor-use only
Temperature
-20 to 70 °C
Relative Humidity
5 to 90% RH, non-condensing
Pollution Degree
2
Altitude
< 2000m
Earth Connection
Yes, terminal based
Emissions
IEC61000-6-4
ESD Immunity
EN 61000-4-2
Radiated RF Immunity
IEC 61000-4-3
EFT/B Immunity
IEC 61000-4-4
Surge Immunity
IEC 61000-4-5
Conducted RF Immunity
IEC 61000-4-6
Zertifikate
UL/cUL; Class1, Div 2 238,99 kB Zuletzt geändert 25.01.2024 ODVA Certification 37,47 kB Zuletzt geändert 25.01.2024 CE Declaration of Conformity (CE, UKCA, RoHS, UL) 570,54 kB Zuletzt geändert 26.06.2026