Abbildungen

Drag with the mouse. Click for close.

Funktionen und Vorteile

• Supports DLR for EtherNet/IP networks
• Support for either EtherNet/IP, Modbus TCP/IP, or Modbus Serial Communication networks.
• PROFIBUS master or slave (with multi-slave support)
• Built-in PROFIBUS packet capture tool

Konfiguration

The PLX50 Configuration Utility software is used for configuration and troubleshooting of the module. The stand-alone configuration utility allows users to define the setup and configuration of the PROFIBUS DP network, connections with Rockwell Automation controllers and devices over EtherNet/IP, and build custom Add-On Instructions (AOIs) to be imported into Studio 5000 applications. 

With the ability to import custom AOI’s into the Studio 5000 environment and advanced PROFIBUS DP tools such as the packet capture utility, commissioning time of a network can be greatly reduced.  

Technische Daten

EtherNet/IP™ Server

As an EtherNet/IP server, the gateway can support up to 4 Class 1 I/O connections back to a Controller on an EtherNet/IP network. Additionally, the server can respond to Class 3 messages from an EtherNet/IP client for the transfer of Status and PROFIBUS DP data.

Modbus TCP/IP

On a Modbus TCP/IP network, the module will operate as either a Modbus TCP/IP Client or Server device.

As a Modbus TCP/IP client the module can be configured to automatically read/write all PROFIBUS DP data with a slave device for easy setup and configuration, or the Modbus Auxiliary Map feature will allow you to configure data transfer to customize the mapping to meet specific application requirements.

As a Modbus TCP/IP Server all information from the PROFIBUS DP network is stored in continuous registers in the module for easy configuration and efficient mapping of data to a Modbus TCP/IP client.

Modbus Serial

On a Modbus Serial network the module will operate as either a Master or a Slave device supporting either RS232 or RS485 communication networks.

As a Modbus Serial Master the module can be configured to automatically read/write all PROFIBUS DP data with a slave device for easy setup and configuration, or the Modbus Auxiliary Map feature will allow you to configure data transfer to customize the mapping to meet specific application requirements.

As a Modbus Serial Slave all information from the PROFIBUS DP network is stored in continuous registers in the module for easy configuration and efficient mapping of data to an attached master device.

PROFIBUS DP Master V1

Cyclic or acyclic data can be transferred with Class 1 or Class 2 DPV1 services, allowing communication with slave devices supporting PROFIBUS DPV0 or V1 protocols. The gateway acts as an input/output link between the PROFIBUS network and the EtherNet/IP protocol. Data transfer by the EtherNet/IP protocol is asynchronous from data transfer on the PROFIBUS network.

• Easy-to-use drag and drop configuration interface via ProSoft PLX50 Configuration Utility
• GSD file import library
• Monitoring and Modification of process data and DPV1 acyclic data
• Multi-drop on a PROFIBUS DPV1 network with other compatible devices
• Automatic project documentation, and Bus Parameter calculation
• Supports online slave diagnostics, and extended diagnostic data (DPV1)
• Auto baud detection at all valid PROFIBUS DPV1 rates up to 12 Mbps
• Master Status LED Indicators for Operations, Network Communication, Master Token-Hold and Network Configuration.
• Up to 125 Slaves can be connected with a repeater
• Up to 1536 cyclic bytes input and 1536 bytes output data
• Supports Extended Diagnostic Data
• Alarm Handling (DPV1)
• Supports Sync and Freeze commands
• Supports PROFIdrive 3.1 compliant parameter read and write operations
  • Supports Multicast and Broadcast telegrams (DPV1)

Hardware-Spezifikationen

Physical

Downloads

Videos

Zertifikate