EtherNet/IP™ to DH+ Gateway
What do you need help with?
What are the bit definitions for the Modem Status Word (N100:40) in the RTU-5/03?
bit 0: CTSs change bit 1: DSR change bit 2: RI change bit 3: CD change bit 4: RTS change bit 5: CTS input state bit 6: RI input state bit 7: CD input state
Erfahren Sie mehrCan the Johnson Control's N2 protocol be used with the RadioLinx FHS Serial radio?
The FHS radios will support the N2 protocol. You must, however, be aware of the following: 200ms timeout- if using protocol mode (including gap timer on) without low latency mode set, the message ... Can the Johnson Control's N2 protocol be used with the RadioLinx FHS Serial radio?
Erfahren Sie mehrWhat are the Industrial Media Convertors, and what do they do?
with an Allen-Bradley Remote I/O network running at 57k6 or 115k2 it is possible to overlay the signals and run both Ethernet based communications and the Remote I/O communications simultaneously. At this time
Erfahren Sie mehrCan the ProSoft DNPSNET solutions support multiple masters (clients)?
. The DNPSNET can generate event data (class 2 and 3) based on a change of data within the processor. Should this module used in a redundant master (client) application, it is recommended to configure the master
Erfahren Sie mehrDo ProSoft AFC Flow Computer solutions support "ASME MFc-6M", "API-11" and/or "API-12" calculation standards for measuring lubricating oils?
The API-11 and API-12 calculations are available in ProSoft AFC Flow Computers, beginning with version 2.05. MPMS Ch 12 specifies, essentially, the necessary factors and calculational sequence
Erfahren Sie mehr