EtherNet/IP™ to DH+ Gateway
What do you need help with?
How can I find the heat-dissipation value for your modules?
converted to heat regardless of how many or what kind of modules are contained in the rack. All that is required is to use the maximum input power to whatever power supply is being used and then multiply by 3
Erfahren Sie mehrWhat are the pin outs for the RJ-45 jack on my Prosoft MVI module?
The pins in the RJ-45 jacks on the MVI-series modules are numbered 1, 2, 3,...8, top to bottom. Pin 1 is the topmost pin in the jack, pin 8 is the bottommost pin in the jack. You can eliminate
Erfahren Sie mehrWhat is the purpose of the battery on the PTQ modules?
, (after about 3 weeks) the CMOS settings would be lost and revert to the default CMOS settings upon power-up. However, it is unlikely the customer would ever change these settings. The RTC is not used
Erfahren Sie mehrIn the GSC modules, what are the possible values for the RxState and Tx State parameter?
for the TXstate parameter are: 0 : waiting for data to send out the port 100 and 101 : message delayed for transmission 1 : RTS on 2 : RTS timeout 30, 31, and 32 : intercharacter delay 3
Erfahren Sie mehrWhat is the bits-per-second (bps) speed of ProSoft Ethernet solutions?
at 10Mbps or 100Mbps, half or full duplex. Most products have Auto-Negotiate capability, and where available default to this setting. PLX3x and PLX8x gateways support 10/100 Mbps and full or half duplex
Erfahren Sie mehr