EtherNet/IP™ to DH+ Gateway
What do you need help with?
The order of bits in the Binary Inputs and Outputs of my PTQ-DNP module appear to be the opposite of what I expect. Why?
reversals. The backplane driver for the PTQ module copies the module's internal 16 bit registers to 3X registers in the Quantum State RAM or from 4X registers to the PTQ. During this backplane copy process
Erfahren Sie mehrThe BATT LED on my ProSoft MVI module is RED. How can I fix this problem?
the BIOS settings which are checked during the boot up of the MVI module. The battery needs to maintain a voltage between 2.3 and 3.7 VDC in order for the BATT LED to be off. If the battery drops below 2.3
Erfahren Sie mehrWhen configuring Siemens ET200M slave (possible other complex PROFIBUS slaves), 1. PDPM master failed to read PT100 AI inputs. 2. Sycon software failed to configure slave parameters, error messages we
scheduled 2nd quarter 2006. 2.The new Sycon v2.91 software has replaced the Sycon v2.71 software on the distribution CD effective 1-12-06. 3.Sales and pre-sales are advised to consider exchanging
Erfahren Sie mehrHow do I increase my ReadData array for an MVI56-MCM module?
The sample ladder file must be modified in 3 locations. Before making these changes, save the work you have already done, as changing this array, may erase any values in your MCM array.1
Erfahren Sie mehrI upgraded my RSLogix5000 software from an older version to Version 16 and now the clock in my MVI56 module does not seem to show the correct time. Why not?
product web page for your specific module or contact ProSoft Technical Support for assistance.
Erfahren Sie mehr