EtherNet/IP™ to DH+ Gateway
What do you need help with?
Read Commands from my Modbus Master to a ProSoft MCM Slave are working but Write Commands are failing. How do I fix this?
device in a multidrop network (RS-422 or RS-485 wiring). In RTU mode, when the module receives sequence of data from another node, it will recognize the end of the message when it detects a 3.5 character
Erfahren Sie mehrWhat AGA specification version is used for Flow Calculations in the ProSoft MVIxx-AFC modules?
The AGA Specifications include Part 1 "General Equations and Uncertainty Guidelines", dated 1990; Part 2 "Specification and Installation Requirements", dated 2000; Part 3 "Natural Gas Applications
Erfahren Sie mehrIn the IEC 60870-5-104 protocol, what is the purpose of the "RESET_PROCESS" command, "C_RP_NC_1"; and what does it do?
procedure to close an open socket connection. On page 45 of the protocol specification, it describes the process as: Figure 20 shows the controlling station establishing a connection by giving an Active
Erfahren Sie mehrHow do I change the name and address of the Site Operator in my Opacts/TermLinx application?
the active site as usual. (2) Menu (3) In the window that opens, click "find". (4) In the list to the left, click (highlight) the entry that represents your site (5) In the panel to the right, note
Erfahren Sie mehrHow do I control Binary Outputs Using the MVI56E-DNPNET Module?
DNP, DNP3, DNPNET, CROB, relay, MVI56E-DNPNET
Erfahren Sie mehr